Print PDF
Favorite
Email
Step 6Make the return spring
The return spring is made out of a used plastic wire tie.
1. Use a straight pin to poke a hole in each end of the wire tie.
2. Put a short piece of 30 awg wire through each end and make a loop big enough to fit over your screws.
1. Use a straight pin to poke a hole in each end of the wire tie.
2. Put a short piece of 30 awg wire through each end and make a loop big enough to fit over your screws.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
