Secret Spy Shoe

Secret Boot Heel Grappling Hook

Supplies
1.  8" of 1/8" steel tubing
2.  10' of 1/16m or 3/32 steel cable
3.  1/16 or 3/32 wire clamps
4.  Old pair of shoes

Tools
1.  Drill
2.  Dremmel
3.  Welder (MIG, ARC, TIG)
4.  Wire cutters

1.  Torch
2.  Vise

Remove these ads by Signing Up

Step 1: Cutting

Mark and cut the 1/8" steel tubing into two four-inch pieces.

Step 2: Bending

I found that the easiest way to bend the tubing was to put the metal in a vise and heat it up as hot as I could.  Then, I was able to bend it into a hook shape.  Do that with both pieces.

Using my MIG welder, I welded the two hooks together.

Step 3: Cutting

Taking the hook and one of the old shoes, I traced out the hook pattern on to the heel of the shoe.  After doing that, I put the shoe in my vice and drilled a 1/4" hole 3/4 of the way through the sole of the shoe.  This is the point where you begin to dremmel.  I dremmeled out a pattern in the shape of the hook into the heel of the shoe.  I then drilled a hole through the heel and into the inside of the shoe.  It is through this that the cable will go.  Once I had the hook well-embedded into the heel of the shoe, I had to glue a small magnet into the heel to secure it.

Step 4:

To store the cable, I decided to use an old sock and a piece of velcro.  I sewed a band of velcro on to the sock so that it formed a little velcro latch that holds the cable.
 1-40 of 70 Next »
chewie6161 year ago
i will have to make it!
santa10102 years ago
florman, you're probably safe, but please keep the following in mind:

If a cable breaks at 120 lbf (pound-force), a 95-lbf person jerking the cable at a rate of 40 ft/sec^2 would break the cable. [Calculation: 120 lbf * 32 ft/sec^2 / 95 lbf = 40 ft/sec^2]

If a 95-lbf person were to swing on a 5-ft cable that breaks at 120 lbf, he would only have to swing 3 miles/hour (about walking speed) to break it. [Calculation: sqrt((120 lbf * 5 ft) / 32 ft/sec^2) ~ 4 ft/sec ~ 3 miles/hour]

(2) Lucky for you, working loads are usually given a safety factor of 5, meaning that your cable shouldn't break until you give it a 600-lbf load. This means you (being 95 lbf) would have to jerk the cable at a rate of 202 ft/sec^2 to break it. You would also break it if you were to swing at about 6 miles/hour with 5 ft of cable.

(3) Unfortunately for frisbeechampe1983's acquiantance, the combination of swinging and abrupt stopping when he hit the wall made a large enough acceleration for the load to exceed the cable's limit.

(4) Additional notes: (a) Make sure you know the difference between mass and weight. (b) The working load limit is determined by a load being uniformly applied in a straight line pull. You are not only changing the load by moving along the cable, but any additional movement on your part makes it risky. (c) The tensile properties of the cable are changed every time you go on and off just because the loads are changing.
florman (author)  santa10101 year ago
Thanks I'l keep that in mind
johnlaw452 years ago
Where are you hiding the pillow you need to sit on after your mom caught you rapelling in your Sunday clothes?
stephenham55112 years ago
saweeeet!!
J-Five2 years ago
You could put a phone in your other shoe!

Wait, I shouldn't give you any ideas.
2 years ago
"This is Maxwell Smart, secret agent 86, calling for Control! Come in, Control!"
D0itYourself2 years ago
Hey mate, nice instructable, but I wouldn't recommend it on the way you use it...
The cable is very thin and you cannot hold it very well for a slow rappel... Probably another use. But GREAT idea
florman (author)  D0itYourself2 years ago
your right about the holding on part of it but the cable is rated at 120 and i'm 95.
2 years ago
Just remember, that 120 is also in force. I knew a kid who tried to rappel a five story gym (our high school gym had roof access.) and he thought 550 would certainly hold him. it did for the first five feet, then he tried to do a jump, when he hit the wall, the 550 snapped. luckily there was grass below him, but he broke his neck. Just remember climbing rope is safely rated at 2200 pounds of force. (22kn)
2 years ago
I don't mean that it gonna brake or something similar, the nature of that cable is not for rappelling
Onyx Ibex2 years ago
Very nice. Can the hook hold all your weight for a ascent or rappel? I made a concealed grappling hook a long while ago. It was a belt. the clasp was a tri-fold and assembled quickly and locked into place. The rope was already tied and acted as a belt. It worked well but was a bit tedious to unwind and rewind around the waist. I like your velcro idea a lot :)
florman (author)  Onyx Ibex2 years ago
thanks and the cable is rated to 120 so i figured since i'm only 95 i'd be okay
Machine2 years ago
Lads, that's a nice grappling hook with cable you've produced, but, it does occur to me that you have greater skills in producing interesting vids to demonstrate your new instructable. Whoever did the editing did a great job and the videoing was done well too.

Here's my suggestion;

Produce a pile more equipment accessories that are wearable and usable in emergencies and get yourselves a brand name too for those devices and vids.

You've got talent, exploit it.

Robert.
florman (author)  Machine2 years ago
thanks
Thundermoon992 years ago
That's legit :)
2 years ago
Correct, this is most definitely an Instructable on how to construct a grappling hook show.
gunshow2 years ago
awsome place to live
florman (author)  gunshow2 years ago
thanks
drdan1522 years ago
Did you get your prize in the mail yet?!!
florman (author)  drdan1522 years ago
No not yet
2 years ago
They just mailed mine a few days ago ..... Hope I get it this week :-)
metroman582 years ago
when it came to the cable storage i think it might work just as well if you laced the shoes with the meatel wireing instead of to ur sock
florman (author)  metroman582 years ago
I tried that but I couldn't fit it all there.
KneXtreme2 years ago
Yay you won first prize! congrats! Yours was my favorite.
florman (author)  KneXtreme2 years ago
Great to hear thanks
Xillra2 years ago
I'm guessing paracord (I HAVE SO MUCH OF IT) will work? The only issue would be thickness, but would give more friction for holding on...?
Any thoughts?
florman (author)  Xillra2 years ago
Paracord would probably work fine but you might want to check the working load on it.
suayres2 years ago
Also, don't cross your leg and rest that foot on your thigh (as so many guys do).
florman (author)  suayres2 years ago
lol
DavidM452 years ago
Nice going kid gotta love it. FYI 1/16" Vectran rope is 800# tensile strength, coils much smaller (as in could store with hook) and 20' weighs less than an oz! The stuff is NOT available at the hardware store (www.APSltd.com) for the serious spy at \$6. BTW: 1/16" 7 strand steel is 500# braking strength I don't know safe working load. Wear heavy gloves for sure!
florman (author)  DavidM452 years ago
Cool I'll add that to my instructable soon
Hate to mention it but now that you have that on instructables every kid and adult will be looking at the heels of everyones' shoes to see if they have one of those...not so secret anymore, huh? :P
olliew722 years ago
This looks like the perfect way to get tackled by a TSA official at the airport! Thanks.
florman (author)  olliew722 years ago
lol
chenghwan2 years ago
But then, it is just a hook, the TSA officer wouldn't mind would they?
2 years ago
Not for genuine spies! ;-)
espdp22 years ago
Sweet idea! I LOVED the video too. Looks like it was really burning your hand by the time you reached ground? :-)
suayres2 years ago
But (sorry, it has to be said), very SMART!
HEY YOU2 years ago
Great Video!!
If you are not concerned with retrieving your hook (Q-branch would give you another in any case), you could use a carabinder on your house keys and webbing (as noted above) for a belt that would likely pass casual inspection.
Well done instructable and great acting.
Cheers
 1-40 of 70 Next »