Print PDF
Favorite
Email
Step 6Setup
This is the easy part. Find two trees between 10 and 15 feet apart. Wrap one of the long cords around the tree, and pull the cord through the end loop (you can start from the knotted end or the other end). Do the same with the other tree. Then simply clip the biners above any figure 8 knot on both cords, and you're done!
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
1
Oct 21, 2011. 6:30 PMpellepeloton
says:
To avoid marking or damaging the bark of the tree you should use tree hugger slings. A separate about 40mm wide sling to wrap around the tree and then tie your cords into these slings.
Reply
 |
Add Comment
|
