Print PDF
Favorite
Email
Step 3Marking Notches and Drill Points for the Arms
A1 and A2 will make up the arms of the swift.
Find the centers of A1 and A2 lengthwise. Measure 0.5" to each side of the center line for both pieces. You have now just marked out the center 1" to be chiseled out. Then mark 0.5" deep of the 1" center -- this is the depth at which you will create the notch. Use the handsaw and saw out slivers within the 1" marks for both pieces.
Find the centers of A1 and A2 lengthwise. Measure 0.5" to each side of the center line for both pieces. You have now just marked out the center 1" to be chiseled out. Then mark 0.5" deep of the 1" center -- this is the depth at which you will create the notch. Use the handsaw and saw out slivers within the 1" marks for both pieces.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
