Introduction: Sherlock Black Lotus Origami.

BY Anriel Almeida.
Make at once if convenient ,if inconvenient make all the same.....

REQUIREMENTS: Square piece of paper approximately 6 and a half inches or 13 cms

Step 1:

Take the piece of paper , keep the colored side face down.
Fold the paper in half, make a sharp crease then fold it in half again,make a sharp crease. Then open all the folds. This will make further folding easier.

Step 2:

Once you have opened up all the previous folds, fold ever corner to the center make sharp creases .The pictures below show the front and back view respectively.

Step 3:

Keeping the folded paper in front view repeat step 2 again.The
picture below shows the front and back view respectively.

Step 4:

Repeat step 3 again.
If you look at the center you will notice 3 layers are formed.

Step 5:

FLIP THE MODEL OVER! ( The only step you flip it over)
Now repeat the same step again.

Step 6:

Repeat the same step again but this time do not fold the corner to
the center but almost three thirds the way to the center.

Step 7:

The first image of the previous step is
considered front and the second back . This part is a bit tricky. Use your left thumb (assuming your right-handed) and place it on the most recent fold and hold the model, place the left index finger on the other side of the model and slip it into the hood of the first fold on the back side.

Using your right index finger and thumb , gently fold it upwards to the top . Keep moving it to the top until a petal (hood) is formed.

Repeat this for the remaining four petals.

Step 8:

Repeat the previous process to make petals of the next layer at
the back

Step 9:

Flip the model over. Fold the last layer as shown in the picture.

Step 10: Your Model Should Look Like This.


MariF19 made it! (author)2017-07-23

This is Prernas work

swagsama1221 (author)2017-06-03

cool! Kind of confusing though... (I like seeing videos for each step cause then it gives me a visual idea of what to do next)


Hi swagsama1221, I'm Anriel., I'm sorry for the delay... I will do my best to make a video.


Hi swagsama1221.. my friend Anriel, the maker of this post is a bit occupied these days, I'm sure she will get back to you with a positive reply!

teehee_infires_panda made it! (author)2017-07-22

Hi!! Made this today.
Thankyou soo much for the tutorial.
The instructions were clear and super easy to follow.?❤


About This Instructable




Bio: ArtPsycho is an exercise for our restless imagination. It is joint platform where the three of us Anriel, Devashree and Jyotsna have been brought together ... More »
More by artpsychoblog:Longclaw ReplicaJon Snow Key ChainHeart Shaped Bookmarks
Add instructable to: