Introduction: Shoebox Gutair!

Picture of Shoebox Gutair!

Step 1: Materials

Picture of Materials

You will need: At least 2 rubber bands At least 2 screws A Shoebox Scissors Ductape A 12 by 3 piece of cardboard

Step 2: Ductape

Picture of Ductape

Tape the top to the bottom of the shoebox

Step 3:

Picture of

Step 4: Cut

Picture of Cut

Start Cutting a circle in the middle of the box

Step 5:

Picture of

Step 6: Cardboard

Picture of Cardboard

Take the excess piece of cardboard and tape it on so it's about 7 inches off the side

Step 7:

Picture of

Step 8: Holes

Picture of Holes

Poke at least two holes in the card board

Step 9: Screws

Picture of Screws

Take at least 2 screws

Step 10:

Picture of

Step 11: Rubber Bands

Picture of Rubber Bands

Take at least 2 rubber bands and tie them to the screws. The screws will tune your gutair.

Step 12:

Picture of

Step 13: Tape

Picture of Tape

Tape the rubber bands right after the circle hike to the shoe box

Step 14: Secure

Picture of Secure

Put a piece of tape between the cardboard and the shoe box to make sure it's secure. There! You are finished. I hope you enjoyed and I would really appreciate if you like this instructable! Thanks and enjoy!

Comments

GBFace (author)2013-09-28

Looks like a tank

james91993 (author)2013-08-09

Super cool