Print PDF
Favorite
Email
Step 3Arranging the wires, and reassembly
1) Pass the wires around the side of the camera, using the same indentation that the blue and white wires use.
2) Replace the front section of the body, and snake the wires around any screw points so that they are tucked into the camera strap anchor.
3) Replace the metal rod, and wrap the wires around it once, to help reduce any pull strain on the wires.
4) Using a craft knife, shave off 2mm from the back camera body section where shown. This will allow space for the wires to pass through.
5) Replace the screw attaching the front of the camera to the internals.
5) Replace the back of the camera, and all screws removed earlier.
2) Replace the front section of the body, and snake the wires around any screw points so that they are tucked into the camera strap anchor.
3) Replace the metal rod, and wrap the wires around it once, to help reduce any pull strain on the wires.
4) Using a craft knife, shave off 2mm from the back camera body section where shown. This will allow space for the wires to pass through.
5) Replace the screw attaching the front of the camera to the internals.
5) Replace the back of the camera, and all screws removed earlier.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
![Hack Your Vivitar Ultra Wide and Slim Camera [Updated]](http://img.instructables.com/files/deriv/FVW/UCVD/G9GQEV1L/FVWUCVDG9GQEV1L.SQUARE.jpg)
