With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
This year at the Trunk O Treat at my church I made the game "Simon Says Narnia". This is the electronic game Simon by Hasbro built into a wooden wardr...
The Simon game lights its colored buttons with 3.5VDC (On State) and 0V (Off State). With this condition a TTL logic device can be used with the Simon...
The wardrobe is constructed from 1"x2" furring strips to make a low cost frame with plywood sheeting on the outside. The sheeting is 1/8" project plyw...
I took apart the handheld Simon game and added external button controls mounted in a wood Wardrobe. The large 2" diameter color Simon game pushbutton...
The game is made with rubber dome chiclet switch pads. The conductive traces on the PCB are normally separated by a non-conductive gaps that when the...
The picture frames are made from cardboard cut 2" wide to make a frame that is 12" x 16". I installed three white LED's in the 12" sides of the frame ...
The function buttons I used was the four color game buttons, game button, level button, start button, and last play button.
Watch the game light up when you press the last game button.
LED Light Strip or LED Bars: Installed inside the wardrobe on the sides and top are LED light strips. The LED light strips are constructed easily and...
See the circuit layout drawing. I put tape over the exposed wires on the back side. This technique makes LED Strip or LED Bar Lights easy to make. I c...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »