Print PDF
Favorite
Email
Step 3Fold a notch
On one of your 9" sections, make two cuts 3/4 of the way through the ruler at 1/2" from the edge and 2-1/8" from the edge.
Place the ruler in a bench vice so that the bottom of the cuts are level with the top of the vice.
Hammer the section between the two cuts flat such that it is made perpendicular.
This will be your motor mount.
Place the ruler in a bench vice so that the bottom of the cuts are level with the top of the vice.
Hammer the section between the two cuts flat such that it is made perpendicular.
This will be your motor mount.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
