I made this at Techshop in SF!
Step 1: Supplies
- Cut out Acrylic Circles (files in next step)
- Jump Rings
- A Clasp
- Needle Nose Pliers
Step 2: Design
The first time I printed this, the circles were under an inch in diameter and the holes I put it that would eventually connect to jump rings, cut the circles in half. I messed around with the design more and was able to get it to work by making the cut holes smaller and then making the overall circle bigger.
Then when I went to cut it for the final time, I saw I had all this extra room. With that in mind, I threw in some more circles in the circles, because wasting is bad. This ended up working well because I used the small circles with the big circles in the necklace and then came up with another very simple earring design. The third picture shows what I eventually cut out.