Step 2: Part 1: Creating the G-code files for The sprocket
If you plan on making the same exact sprocket as the one in this guide, download the posted G-code file and load it into mach3.
If you plan on making your own custom sprocket, then make sure you tell the CAM software to ONLY cut the outside teeth of the sprocket. It should look something like the toolpath in the picture.
If you plan on making your own custom sprocket, then make sure you tell the CAM software to ONLY cut the outside teeth of the sprocket. It should look something like the toolpath in the picture.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
