Introduction: Simple K'NEX Gun

By
About: Studying Electrical Engineering at Iowa State University.

Very Simple K'NEX Gun. Something fun to shoot with. Caution: not responsible for any injuries or damages caused by building or shooting of this gun.

Step 1: Assembly

Self Explanatory.

Step 2: Assembly Cont.

Use a knife/scissors or pull a rubber band apart till it breaks. Don't poke your eye out!

Step 3: Assembly Cont.

Take one end of the broken rubber band, and stick it in between the rod and the two connectors. You'll probably have to take a rod or two off to get the rubber band in place. Don't forget to put the "firing mechanism" on the rubber band too.

Step 4: Finished!

Pull the "firing mechanism" back. Put the holder down. Load ammo and fire. Have fun!