Print PDF
Favorite
Email
Step 3Stitching
This step is made alot easier by the fact that we cheated and drilled our holes!
Picture 1 - Clamp the pages together, i did this by holding on tight to the book, then sliding the card out from the previous step, This helps to keep the pages perfectly aligned.
Picture 2 - Thread your needle, You want a length of thread about 300mm long. The needle itself wants to be the thinnest one you can find.
Picture 3 - Push the needle through the gap, it should practically fall through (if it doesn't, you need a smaller needle). Tie a simple knot to hold it in place.
Picture 4 - Wrap the thread around, and around, until the needle wont fit through the hole anymore, then wrap the thread around it self, and tie it off.
Picture 5 - This shows one hole completed.
Picture 6 - Repeat for the other three holes.
Picture 1 - Clamp the pages together, i did this by holding on tight to the book, then sliding the card out from the previous step, This helps to keep the pages perfectly aligned.
Picture 2 - Thread your needle, You want a length of thread about 300mm long. The needle itself wants to be the thinnest one you can find.
Picture 3 - Push the needle through the gap, it should practically fall through (if it doesn't, you need a smaller needle). Tie a simple knot to hold it in place.
Picture 4 - Wrap the thread around, and around, until the needle wont fit through the hole anymore, then wrap the thread around it self, and tie it off.
Picture 5 - This shows one hole completed.
Picture 6 - Repeat for the other three holes.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
