Introduction: Simple Led Patterns (Using Arduino)

This is a basic project that will definitely help you in understanding the basics of Arduino and the output is satisfying too.The components used in this project are easily available and are included in most starter packs.

COMPONENTS REQUIRED

  • Arduino Board
  • Resistors (220 ohms)
  • LEDs
  • Connecting wires
  • Breadboard

Step 1: Components Required

Picture of Components Required
  1. Arduino Micro controller Board
  2. Resistors (220 ohms)
  3. LEDs
  4. Connecting wires
  5. Breadboard

Step 2: Process

Picture of Process

Insert the connecting wiresinto the digital pins 1,3,5,7 and also one in the ground pin, insert the other end of these wires into the breadboard with ground wire taken care of. Now inser the LEDs and the 220 ohms resistor accordingly, copy the provided Arduino sketch (program) and uppload it to the Arduino board, that is all you need to do, feel free to mess with the parameters in the Arduino program and get started!

Comments

DIY Hacks and How Tos (author)2017-01-15

Great first instructable. You should enter it into the First Time Authors contest.

About This Instructable

382views

5favorites

Bio: Electrical Engineer and a tech enthusiast.
More by Sagar_1947:DIY Synthesizer Simple Led Patterns (Using Arduino)
Add instructable to: