Print PDF
Favorite
Email
Step 2Cut out two block's of rubber
Bend the the Metal Mesh Document Holder so that the long sides lie flat, and flip it upside down so that the short edge sits on the desk. The weight of the laptop will hold the long side flat.
Cut the block of rubber into two pieces using a utility blade.
Using a glue gun, glue each piece to the corner of the Metal Document holder (Glue to the bended edge). This will prevent the laptop from slipping when sitting at an angle.
Cut the block of rubber into two pieces using a utility blade.
Using a glue gun, glue each piece to the corner of the Metal Document holder (Glue to the bended edge). This will prevent the laptop from slipping when sitting at an angle.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
