Print PDF
Favorite
Email
Step 13Operation: Adjust the center setting
Center the knob by lining it up with the line printed on the back of the board
Using a small screwdriver, adjust the trim pot until your servo is centered. I have found that 1/8 to 1/4 turn clockwise is needed to center the servo.
ALL DONE! ENJOY YOUR NEW TOOL!
Using a small screwdriver, adjust the trim pot until your servo is centered. I have found that 1/8 to 1/4 turn clockwise is needed to center the servo.
ALL DONE! ENJOY YOUR NEW TOOL!
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
