Print PDF
Favorite
Email
Step 7Make: Install the right angle pin headers
Snip apart the pin headers so that you have three of them with three pins each.
Solder just the center pin of each header. Then pick up the board and reheat the center pin while applying pressure from the other side to snap it in place. This is an easy way to insure that the headers are flush and straight.
Don't forget to solder the rest of the pins when you are satisfied with the alignment.
Solder just the center pin of each header. Then pick up the board and reheat the center pin while applying pressure from the other side to snap it in place. This is an easy way to insure that the headers are flush and straight.
Don't forget to solder the rest of the pins when you are satisfied with the alignment.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
