Step 2:
Assembly
After you gathered all the materials required, it is time to glue down the materials.
First, glue the smaller rod to one side of the base. Then, measure the distance with your laptop to where the back rod has to go. Make sure to put it in a place where it will be stable.
Put extra hot glue on both sides of each rod to make sure it is secured.
And you are done.
After you gathered all the materials required, it is time to glue down the materials.
First, glue the smaller rod to one side of the base. Then, measure the distance with your laptop to where the back rod has to go. Make sure to put it in a place where it will be stable.
Put extra hot glue on both sides of each rod to make sure it is secured.
And you are done.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
