Print PDF
Favorite
Email
Step 2Create Channel for Wires
The wires that connect the LEDs at the front and the back of the Skateboard to the circuit board are installed in the fourth (middle) laminate of the skateboard.
1. After 24 hours remove the first three laminates from the vacuum bag.
2. Cut a channel/groove into the fourth laminate.
3. Add glue to the top of the first three laminate.
4. Place the fourth laminate on top of the assemble.
5. Place the assembly onto the foam mold, insert guide pin.
6. Place the entire assembly into the netting, then vacuum bag, and vacuum all the air out again.
1. After 24 hours remove the first three laminates from the vacuum bag.
2. Cut a channel/groove into the fourth laminate.
3. Add glue to the top of the first three laminate.
4. Place the fourth laminate on top of the assemble.
5. Place the assembly onto the foam mold, insert guide pin.
6. Place the entire assembly into the netting, then vacuum bag, and vacuum all the air out again.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
