Print PDF
Favorite
Email
Step 3Put your left foot in, take your left foot out...
As we construct the slippers, we will be doing everything inside out so that where we sew, it will create a nice finished seam when the object is flipped inside out.
Double over a piece of material so that we can mark and cut out the top and bottom of the slipper.
Place your sock tracing templates over the material.
Now flip over the templates. We are working inside out so all of the markings will not show up in the finished product.
Draw a big foot around the template, keep in mind where the big toe should be. Also allow about an inch to 2 inches to make the foot bigger and for seam allowance.
Since you are looking at pictures of the prototype, I would suggest drawing the toes spread out a bit so you can easier sew them to cut apart. Give about a half inch between the toes.
Double over a piece of material so that we can mark and cut out the top and bottom of the slipper.
Place your sock tracing templates over the material.
Now flip over the templates. We are working inside out so all of the markings will not show up in the finished product.
Draw a big foot around the template, keep in mind where the big toe should be. Also allow about an inch to 2 inches to make the foot bigger and for seam allowance.
Since you are looking at pictures of the prototype, I would suggest drawing the toes spread out a bit so you can easier sew them to cut apart. Give about a half inch between the toes.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
