With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
It starts out easy enough: A boy, building furniture with his dad. Well, we wanted to build furniture, but all they did was build one horrendously ove...
To begin, mark each of the 2x6's on one of their wide faces - whichever face you want to be against the wall, preferably. These markings will be for 2...
Once you have all the 2x6's marked, move onto the 2x4x's. THESE NEED TO BE MARKED VERY PRECISELY, since these spaces are the key to the shelving.You n...
If you have excess left on your 2x4's , shave it off with your saw. If you'd like. I'm not telling you what to do or anything. Double check your marks...
Literally. Screw the #12's into the 2x6's and the 2x4's to bond them. Take the time to line all the holes up appropriately, and the boards with all th...
To make sure this simple thing that'll hold all of your precious electronics stays upright, you'll probably need a stand. It is a simple design, but t...
If your power saw has a level system, set it to (guess) 45 degrees. Lie the lumber on the fat side, and cut into the 2x4x18" mounting notches, stoppin...
With the fat bit (1/2" bit), drill between to cuts you just made in the 2x4x6's, but make sure the hole doesn't extend beyond that stop line. Drill al...
The shelves in this are actually really easy. First, take the 1" x 1" x 16" shafts and mark them 3" and 4" from one end. This is where you're going to...
Once those are in place, measure 1 7/8" from the rear of the cube, and mark the shaft. Measure 1/4" behind that mark, and mark as close to the middle ...
Mark off the 1/2" dowel in increments of 2 1/2". Cut the dowel into those chunks - the hand saw would probably be best for this. Test your shelf by p...
That's really the key here: Any shelving can be made with the stops in front and the locks in back. I've already done one basic, classic shelf, and am...
Drop the slate into the stands on their corresponding sides. Next, lock the shelves in and load 'er up, CAREFULLY! Depending on the final load, you ma...
Now, I think this will do us well for the future. If I could do it again, though, I might change some things. Thankfully, you folks can do it again! C...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »