Small Engine Rewind Starter Pull Cord and Handle Replacement

Step 3 Install replacement cord

I started by aligning the hole in the housing with the hole in the pulley, and then threaded the cord through both the housing and the pulley using my pliers.

I then tied a knot on the end of the cord I just pulled through.
NOTE: I do believe you are supposed to use a left hand knot on the cord, as my images show...I definitely did not. I intend to fix this when I have time.

I then pulled the cord back out of the assembly and pushed the knot into a recessed area in the pulley with my pliers.