Print PDF
Favorite
Email
Step 6Prepare the cork
As you can see in the first image, the housing has a cup like thingy where the cord enters the housing. I assume this is to prevent debris from entering the housing and messing up the innards of the starter.
I decided to make use of an old latex cork to fit into the thingy for that very purpose.
I cut about a half inch off the cork since it needn't be that long. I then drilled a hole through the cork so that I could thread it along my rope before the handle.
I decided to make use of an old latex cork to fit into the thingy for that very purpose.
I cut about a half inch off the cork since it needn't be that long. I then drilled a hole through the cork so that I could thread it along my rope before the handle.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
