Print PDF
Favorite
Email
Step 5Attaching the ilt switch, gluing the body
After wiring the tilt switch, angle it so that it will be off when the coaster is flat on the table. 30 degrees should do it. Glue it in place.
Stack the disc and doughnuts, and glue them together. You can use more exotic acrylic glues, but since this isn't load bearing, a thick epoxy will do.
Stack the disc and doughnuts, and glue them together. You can use more exotic acrylic glues, but since this isn't load bearing, a thick epoxy will do.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
