Instructables
Picture of Smooth Boat on ACAD 2000
This 'able will teach you how to create a smooth solid boat front in ACAD 2000

Step 1: The first dimension

Picture of The first dimension
Start by drawing a rectangle that will be the length and width of the front of your boat

This will be in the TOP view

Step 3: Draw the outline of your boat (cont.)

Picture of Draw the outline of your boat (cont.)
i will take you through step by step for the first view

Step 4: Draw the outline of your boat (cont.)

Picture of Draw the outline of your boat (cont.)
half of your top veiw

Step 5: Draw the outline of your boat (cont.)

Picture of Draw the outline of your boat (cont.)
and mirror it over

Step 6: The Second Dimension

Picture of The Second Dimension
Switch to the FRONT view

Step 7: Front Outline

Picture of Front Outline
Draw a rectangle the length and height of the front of your boat, this will be placed right on the first dimension

Step 8: What You Have So Far

Picture of What You Have So Far
This is what your drawing should look like in free space

Step 9: Front Outline (cont.)

Picture of Front Outline (cont.)
Draw the outline of your boat from the side

You will be using POLYLINE for this

Step 10: The Third Dimension

Picture of The Third Dimension
Now switch to the RIGHT view

And draw a rectangle that is the height and width of the front of your boat

This rectangle should fit with the previous two dimensions

Step 11: What You Should Have So Far

Picture of What You Should Have So Far
This is what your drawing should look like in free space

Step 12: Right Outline

Picture of Right Outline
Now draw the outline of your boat that will be seen from the front

You will be using POLYLINE for this

Step 13: What You Should Have So Far

Picture of What You Should Have So Far
This is what your drawing should look like in free space

You will also need to be in a view similar to this for the next steps

Step 14: Extruding

Picture of Extruding
Extrude each dimension

Step 15: Extruding

Picture of Extruding
Extrude each dimension

Step 16: Extruding

Picture of Extruding
Extrude each dimension

Step 17: Unioning

Picture of Unioning
Be sure that each dimension is one piece

this will require UNIONing separate half's together

You will be left with 3 solids

Step 18: Intersect

Picture of Intersect
Select all three solids and INTERSECT them

You will be left with something similar to the picture below

Step 19: Fillet

Picture of Fillet
Begin your smoothing out by FILLETing the edges shown below

Perform each FILLET seperatly

You will have to experiment with FILLET RADIUS's until you get the results you want

If you receive an ERROR, try a smaller RADIUS

Step 20: Fillet (cont.)

Picture of Fillet (cont.)
Now FILLET this edge on both sides of the solid

You will follow the same guidelines as in the previous step

Step 21: End Product

Picture of End Product
This is what you will be left with once you have completed the steps
 
Remove these adsRemove these ads by Signing Up