Snow Clock (Arduino Based)

Step 2 Hack the Alarm Clock

The first step to this is going to be the Alarm Clock.

First take apart your alarm clock and find were the switch is. Get to where the switch is and solder two wires to that. Now you can take out were the old button was and route the wire along the alarm clock. Then take some CAT5e, strip the end and then use the blue pair and connect them to the two wires that we soldered to the alarm clock. Now bend the other pairs on the CAT5e cable back a little so now you can use them to hold the wire in.

Now you have successfully hacked your alarm clock.
If you have ran into trouble here read the bottom of the first page on this instructable.