Print PDF
Favorite
Email
Step 8Start on the Trunk
As you could see in a prior step, you shouldn't just drop all the layers on top of each other. This is where the cylindrical parts come in.
This part is just a short, wide cylinder that props up a couple layers. But it's important to get the spacing right; just a little bit should do, but you want it to remain hidden under the branch layers.
I suppose a good formula would be to make it's height about 1/3 the length of the seam on the layer it sits on.
This part is just a short, wide cylinder that props up a couple layers. But it's important to get the spacing right; just a little bit should do, but you want it to remain hidden under the branch layers.
I suppose a good formula would be to make it's height about 1/3 the length of the seam on the layer it sits on.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
