Print PDF
Favorite
Email
Step 6Fin supports
This step may not be needed, but I figured better safe than sorry...
Using some of the scrap pieces of foam core, I cut 6 small triangles. (approx 1" x 1.5"). These will be added to your fins later for extra support.
Using some of the scrap pieces of foam core, I cut 6 small triangles. (approx 1" x 1.5"). These will be added to your fins later for extra support.
| « Previous Step | Download PDFView All Steps | Next Step » |
3
comments
|
Add Comment
|
Jun 18, 2011. 5:27 PMskuxx deluxx
says:
Sweet paint job!!!
Reply
Jan 29, 2011. 11:05 AMTheRocker71
says:
Is there a PDF for these supports?
Reply
1
Jan 29, 2011. 2:40 PM
cyenobite (author)
says:
cyenobite (author)
says:
No, sorry. No need for a pdf, as they are just small triangles. They really don't need to be triangles either, I just decided to put them on for added support using some left over foamcore. Hope that helps.
Reply
 |
Add Comment
|
