With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
SOLAR POWERED REVERSE TRIKE Designed and built in just 18 days at the University of Engineering and Technology Lahore in Pakistan, 7 x 3.5 x 4.5 f...
First of all i made the 3D design of the vehicle in Solid Edge v20. Below are the picture of the vehicle. This was a vital step in fabrication of the ...
After the 3D design of the vehicle was completed i stated the fabrication of the Chassis. I used Aluminum rectangular Sections 2"x1", thickness 2mm fo...
I used a rear section of the bicyle to hold the rear wheels.... which was later used to drive the vehicle!
Next step was to assemble the fabricated front part of the chassis with the rear section taken from a used bicycle! U-shaped bar was used to hold the ...
Next step was to mount the wheels on the vehicle....
Since this a reverse trike so front two tires were to be used for steering ...... so i used T-joint mechanism to steer the wheels!....
A small frame was made to support both the motor and the battery, using angle irons....
To mount the solar panel on the top of the vehicle a frame was to be designed as in 3D model.... so finally it was welded on the base of the chassis
Purpose of the charge controller circuit is to cutoff the supply from the solar panel when the battery is fully charged to avoid over charging... and ...
And finally an other addition to Green Technology! and after series of experiments i conclude the following results RESULTS 1. It can go upto 30kmph...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »