Print PDF
Favorite
Email
Step 9Attach the crystals
Tie a 10cm loop of thin thread or fishing line round the crystal and then thread this through the connector block. Put the crystal through this loop and pull tight.
Then put the connector block on the gearbox shaft and tighten up.
There isn't a right or wrong way to do this, as long as the crystals are firmly attached to the shaft of the gearbox.
Then put the connector block on the gearbox shaft and tighten up.
There isn't a right or wrong way to do this, as long as the crystals are firmly attached to the shaft of the gearbox.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
