Print PDF
Favorite
Email
Step 5Install the LED's on the spool
After you solder the wires on the motor and taped the aluminum foil tape on the spool, it is now time to install the LED's on the spool...
Cut out two pieces of 3X12 veroboard from a big piece of veroboard using the dremel tool or other cutting tools.
Solder LED's, resistors, wires, and cut track like in this diagram below, and watch out for the polarity of the LED's!
Once you have done all of the soldering, glue the veroboard with LED's onto the spool, and make sure you glue the veroboard with LED's and wires very well onto the spool otherwise thing may go flying straight off the spool and hit other things or people if they are close the device.
Cut out two pieces of 3X12 veroboard from a big piece of veroboard using the dremel tool or other cutting tools.
Solder LED's, resistors, wires, and cut track like in this diagram below, and watch out for the polarity of the LED's!
Once you have done all of the soldering, glue the veroboard with LED's onto the spool, and make sure you glue the veroboard with LED's and wires very well onto the spool otherwise thing may go flying straight off the spool and hit other things or people if they are close the device.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Aug 29, 2011. 6:57 AMpmonica
says:
could u be plz be clearer on where the wires from the centre of the spool go???this part s a bit difficult to understand.......
Reply
Oct 7, 2010. 5:15 PM7samuel
says:
this is one of the parts that i get lost in can you go over it with more detail?
Reply
 |
Add Comment
|
