Print PDF
Favorite
Email
Step 6Adding the holder onto the motor
I used a small spool that was once used to hold wires but it is now used to support the motor.
The core of the small spool was slightly wider than the motor so I simply wrapped about 10 turns of masking tape around the motor and it fits smugly into the core of the small spool, and I put some glue between the motor and the small spool.
I had also soldered two wires to the motor's leads.
The core of the small spool was slightly wider than the motor so I simply wrapped about 10 turns of masking tape around the motor and it fits smugly into the core of the small spool, and I put some glue between the motor and the small spool.
I had also soldered two wires to the motor's leads.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
