Introduction: Staple Remover Dragon

Picture of Staple Remover Dragon

Add a little fantasy to your reality withthis simple project

So for this project you will need the following materials:

1 staple remover
2 sheets paper
washable school glue
2 squares facial tissue
sand paper, rough
primer
paint.

Step 1: A Good Start

Picture of A Good Start

Step one
sand all plastic surfaces of the staple remover,
then cover in a layer of paper by gluing on small strips
it is best to coat the entire strip with glue rather than applying glue
to the main structure.

Step 2: The Eyes Have It

Picture of The Eyes Have It

step two
roll two small paper balls for eyes and glue to top.
next fold a thick strip to place atop the eyes forming the brow ridge

Step 3: Horns

Picture of Horns

step three
form a horn by folding a 4 in x 1.5 in strip into thirds long ways creating a 4x .5 in. strip and roll it into a spiraling cone clockways. crate the second by rolling counter-clockways. attach these behind the eyes.

Step 4: Jaw Dropper

Picture of Jaw Dropper

step four
Build up the lower jaw in the same manner used to make the horns, or sculp to your own fancy.

Step 5: Smoothing

Picture of Smoothing

Step Five.

Now apply the facial tissue over all papered areas to smooth out seems and fill gaps.
allow to dry completly before moving on to the next step.

Step 6: Paint

Picture of Paint

step six
once the glue has dried apply a primer. I prefer grey but black will give your dragon a more sinister feel.
after primer drying is complete paint with water based acryllics, and enjoy.

Comments

Penolopy Bulnick (author)2012-09-07

Ha! Awesome idea :)

raith (author)Penolopy Bulnick2012-09-07

Thank you much!

ChrysN (author)2012-09-07

Cool idea!

About This Instructable

700views

1favorite

License:

More by raith:Joker MuppetMac Guyver Wart removalKnife switch
Add instructable to: