Print PDF
Favorite
Email
Step 3Connect the Pedal
We'll start with the foot pedal. Somewhere on the actual switch located inside the foot pedal, solder your two wires onto either side of the switch. Then, find a convenient place for the wires to leave out of the foot pedal.
In my version, I soldered two small wires first, then soldered them onto a cut-open section of guitar cord that I then passed through one of the output jacks, since I'm not really going to use this pedal for anything but this. If you're using your own jack, solder the male end of the jack onto the free end of the wire.
Put the pedal back together.
In my version, I soldered two small wires first, then soldered them onto a cut-open section of guitar cord that I then passed through one of the output jacks, since I'm not really going to use this pedal for anything but this. If you're using your own jack, solder the male end of the jack onto the free end of the wire.
Put the pedal back together.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
