Print PDF
Favorite
Email
Step 5Foiling
-Cut a piece of aluminum foil. Decide on which side you want to use as one side is shiney and the other matte.
-Glue stick the opposite side of the foil that you want.
-Glently place the face of the badge against the glued side of the foil.
-Flip it over and with a cuetip gently rub the foil onto the badge.
-Cut the access foil around the badge leaving enough to fold over the endges.
-Apply glue to the sides and back of the padge and gently fold the foil over the edges of the badge.
-Glue stick the opposite side of the foil that you want.
-Glently place the face of the badge against the glued side of the foil.
-Flip it over and with a cuetip gently rub the foil onto the badge.
-Cut the access foil around the badge leaving enough to fold over the endges.
-Apply glue to the sides and back of the padge and gently fold the foil over the edges of the badge.
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Dec 7, 2009. 7:19 PMwetkiss
says:
How did you make it so that the foil didn't get all wrinkled
Reply
1
Dec 16, 2009. 7:12 AMcannonwashburn (author)
says:
I was very careful to wrinkle it as little as possible when I cut it out from the role. Once glued on rubbing the foil onto the badge while it is still wet helps remove some wrinkles as well. The end product has a few small wrinkles that we only seen when you look really closely at it. Hope that helps.
Reply
 |
Add Comment
|
