Print PDF
Favorite
Email
Step 3Trim the lens cap on the goggles
Place a sanding attachment into the rotary tool. Wearing your eye protection trim the outside of the lens cap by sanding it down just enough for it to fit into the cut bottle.
Note:
Wear your goggles.
I recommend wearing a long sleeved top for this step, the plastic flies everywhere.
After trimming, clean the lens cap, and the inside of the bottle with rubbing alcohol to remove any residue.
Warning:
The plastic you are sanding off becomes very hot, and has sharp edges. Seek medical attention immediately if it enters your eye.
Note:
Wear your goggles.
I recommend wearing a long sleeved top for this step, the plastic flies everywhere.
After trimming, clean the lens cap, and the inside of the bottle with rubbing alcohol to remove any residue.
Warning:
The plastic you are sanding off becomes very hot, and has sharp edges. Seek medical attention immediately if it enters your eye.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
