Print PDF
Favorite
Email
Step 5Assembly
This is probably the fiddliest bit. You are going to assemble the liner into the outer helmet and sew them together.
It is probably helpful now to put the liner into the helmet and try it on in front of a mirror, so you can pull everything into place. you can see in the first picture that the liner is sticking out because my cutting was not very precise. This doesnt matter as it makes it easier to adjust now.
1. sew your chinstrap on and any buttons
2. sew the bottom edge, round the neck, first, and then try it on again to make sure all is right.
3. sew the front edge, round the face
4. Trim all round to make a neat edge
This could probably be done by gluing or stapling if not sewing.
It is probably helpful now to put the liner into the helmet and try it on in front of a mirror, so you can pull everything into place. you can see in the first picture that the liner is sticking out because my cutting was not very precise. This doesnt matter as it makes it easier to adjust now.
1. sew your chinstrap on and any buttons
2. sew the bottom edge, round the neck, first, and then try it on again to make sure all is right.
3. sew the front edge, round the face
4. Trim all round to make a neat edge
This could probably be done by gluing or stapling if not sewing.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
