Step 2: Twist
Fold the wires in half. Anchor the looped ends. Again, I used my hammer while stepping on it.
Arrange the wires so they are free of any tangles and clamp them in the jaws of locking pliers.
Twist the wires until you have your desired amount of twists in it.
Cut the looped end open and remove it from the anchor.
Arrange the wires so they are free of any tangles and clamp them in the jaws of locking pliers.
Twist the wires until you have your desired amount of twists in it.
Cut the looped end open and remove it from the anchor.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
zombie1212
says:
Jul 11, 2011. 11:07 AMReply
very well done you explained it very well, I cant wait to make on.
Visit Our Store »
Go Pro Today »
