Print PDF
Favorite
Email
Step 2Cut your acrylic
Cut your acrylic using the following templates below.
One is for the bracket that holds the microphones, another other is a cover to make the base of the mic look all pretty-like and the last is a perf. board for building the circuit (print 2 or 3 of these using your extra scrap material after making the other cuts).
I laser cut them with a 75W laser with the following settings:
Speed: 12
Power: 100
Frequency: 5000
If you don't have a laser cutter, print out the template and tape or draw them onto your material. Proceed to cut them out with the tools you have.
One is for the bracket that holds the microphones, another other is a cover to make the base of the mic look all pretty-like and the last is a perf. board for building the circuit (print 2 or 3 of these using your extra scrap material after making the other cuts).
I laser cut them with a 75W laser with the following settings:
Speed: 12
Power: 100
Frequency: 5000
If you don't have a laser cutter, print out the template and tape or draw them onto your material. Proceed to cut them out with the tools you have.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
