My first mod of a standard USB Drive using a StressBuster ball.
Credits to killerjackalope for foam apple thumb drive.
Step 1: Tools Required
A StressBuster Ball
A Standard USB Drive
Craft Knife or any other cutting tool of your choice
Step 2: Make way for the drive
Using the cutting tool make incision in the StressBuster ball. The knife can be heated using the candle, it make better incisions. Make Sure that the width of the incision is a little smaller than the drive's width for a snug fit.
Step 3: Push the drive in
After the incision is sufficient, push the drive in the incision.
I used spiral motion to make way.