1x Atmel ATMega168 = �2.65
1x Stipboard = 72p
1x 7805 Voltage regulator = 26p
2x LEDs = 16p
2x 220 Ohm resistors = 8p
1x 10k Ohm resistor = 4p
2x 10 uF capacitors = 12p
1x 16 MHz clock crystal = 45p
2x 22 pF capacitors = 10p
2x .1 mfd capacitors = 10p
1x small momentary button = 18p
# small amount of wire for jumpers
Total = �5.94
(All prices based on single component prices from bitsbox)
Step 1: Cutting the tracks
Below is a guide on what tracks to cut, and how to place the components for soldering.
Step 2: Go Custom!
Now feel free to add male pins, sockets, ICSP, extra regulated +5v and ground pins......if it fits on your breadbord, it will fit on your Stripduino!
Would love to hear any feedback on this project, and hear how you would go about changing the designs.
Step 3: Interfaceing
Step 4: Programming/Bootloader
you could also play about with fitting a a 7404 integrated circuit and DB-9 serial connector using this guide here http://www.arduino.cc/en/Main/StandaloneAssembly