Print PDF
Favorite
Email
Step 4Programming/Bootloader
You can program this Stripduino with the easy addition of a 6 pins (ISP) for use with a a 6-pin AVR Programmer Cable.
you could also play about with fitting a a 7404 integrated circuit and DB-9 serial connector using this guide here http://www.arduino.cc/en/Main/StandaloneAssembly
you could also play about with fitting a a 7404 integrated circuit and DB-9 serial connector using this guide here http://www.arduino.cc/en/Main/StandaloneAssembly
| « Previous Step | Download PDFView All Steps | Next Step » |
2
comments
|
Add Comment
|
Aug 30, 2009. 3:01 PMProtons
says:
what should pins 2 and 6 on the isp be connected to? ground on the chip (pin 8) and vcc on the chip (pin 7) or left un connected? thanks again
Reply
5
Aug 30, 2009. 3:31 PM
icecreamterror (author)
says:
icecreamterror (author)
says:
Hello mate 2, and 6 on the ISP are VVC (+5v) and GND (ground), so don't have to be connected to anything, as long as the StripDuino is attached to a battery and the power light is on.
Reply
 |
Add Comment
|
