Print PDF
Favorite
Email
Step 7Slit the Hood up the middle
Create a slit up the middle of the hood, to create an overlap. This tapers the shape of the hood from large at the top to smaller at the bottom.
Use scrap cardboard to create a rigid form to help the bottom of the hood keep its shape. I used a piece of 1/2 inch thick rigid foam insulation instead of card board.
Tape the rigid form to the hood and dryer.
Use scrap cardboard to create a rigid form to help the bottom of the hood keep its shape. I used a piece of 1/2 inch thick rigid foam insulation instead of card board.
Tape the rigid form to the hood and dryer.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
