Introduction: Super Simple Salsa

This salsa takes about ten minutes to make and requires very few ingredients. It can be made in single serving sizes or in large quantities.

Step 1: Ingredients

The way I've done this is to open cans of each of the "wet" ingredients (Beans, corn and tomatoes) and make individual servings from the open cans. This way I can make it fresh every time. Then I can just wrap the tops of the cans with tin foil and save them for later.

You will need:
Black Beans
Whole Kernel Corn
Diced Tomatoes with Green Chiles
An Onion
Cilantro (Either Fresh Chopped or Dried)
Taco Sauce (I used a packet of Taco Bell Fire Sauce)
Garlic Powder
Crushed Red Pepper

Step 2: Mixing Ingredients

1. Start with about 3 Tbsp of the Tomato mix, drain off liquid.
2. Add about 1 Tbsp of Beans, again drain then add.
3. Repeat with the Corn.
4. Add about 2 tsp of Taco Sauce or 1 sauce packet
5. Add Garlic Powder, Cilantro, and Crushed Red Pepper
6. Chop and add about 1 Tbsp of onion.
7. Mix!

Sorry for the poor picture quality.

Step 3: Finish and Serve

I find the salsa tastes best after it's been microwaved for about 45 seconds. 1 minute gets it a little too hot and 30 seconds is not quite hot enough. Heating the salsa allows the flavors of the garlic, cilantro, and the pepper to meld their way into the tomatoes. It also forces some of the water out of the tomatoes, as well as working to soften the onions. From here you can either eat it hot (which is actually pretty good) or stick it in the refrigerator to let it cool.

Enjoy!

Comments

About This Instructable

477views

1favorite

License:

More by Schober:Coffee Creme BruleeSuper Simple SalsaLighted Portal Warning Symbol
Add instructable to: