This instructable will show you how to make a super sled.
A super sled is designed as an all in one cutting table for your table saw, replacing the original mitre and fence.
the adjustable arms can be adjusted to any angle for any job type
I made this because my miter was insufficient and was having trouble cutting correct angles.
i have adjusted the text it should all be Arial 9 and all black text
thank you for your feed back
Please enjoy the instructable .
All feedback is welcome including
Step 1: Tools needed
Several G clamps
Long straight edge ruler
Drill with ¾ and 3/8 bits
Heaps of sand paper
60 12mm screws
26 25mm screws
6 40mm screws
2 65mm batten screws
Square with 45 degree pre set
Saw rip or tennon
Philips head screwdriver or bit for drill
Dowel x 2 and matching drill bit
Two steel rulers
2 triangular drafting square.
Countersunk piece or 9mm drill bit
Step 2: Timber Needed
1 2x4 ft board >cut down to size
1 48 inch x 1 ¾ x 3 inch hard wood
1 8 ½ x 6 ½ hard wood
1 90 x 45 mm x 300mm (12 inches)
2 2 ½ ft thin plastic or runners timber
Step 3: Base
Draw a line from each corner to the diagonal opposite making a really large X on your board. They should intersect where your centre line is. Hopefully
You can do this in any order. Draw your x first then measure your centre line or mark the centre line first
I have called a hole where the router goes all the way through the timber a (through and through )
Having a long writers block. lol sory