Introduction: TAPLABS

hi and welcome to the construction of my makerspace

after hunting for a nice little spot to start up I set about to make a fun space ..

I had over the years collected many things from large printers to vinyl cutters and tshirt presses

so I thought I had all the makings of a makerspace and decided what the H lets go for it

Step 1: THE BUILD

So here we go of to the local store I returned with a bunch of 8 x4 3/4 plywood and a bunch of 2x4 x 8
then with a table saw and some screws i built work benches around 2 3rds of the place
I had the ply pre-cut at the store ..so it became 8x3 and used the cut off piece as shelving

as you can see in the pics ..some late nights were needed to get it finished

Step 2: FILLING THE SPACE WITH GOODIES

So here we go start filling in ..putting up more shelves adding storage and storage bins

oh look there's me setting up my computer spot

Step 3: BRINGING IN THE TOYS

next we start unpacking and moving things into place
some of the gear we have

24 inch printer
laser cutter 30 watt 12x16
replicatror 2 3d printer
hadron ordbot 3d printer
hadron ordbot 3d printer
replaicator dual 3d printer
punctec xl 3d printer
TJET2 direct to garment printer
24 inch vinyl cutter
hat press
t shirt ptress
diamond blade glass bandsaw
diamond glass grinder
soldering stations
tools galore
30 gallon air compressor
and we are always aquiring more

Step 4: SEPT 28 AND ITS a FULL ON MAKERSPACE

Step 5: FINALLY a LITTLE TOUR

Comments