Introduction: Tape Bot

Picture of Tape Bot

This is just a fun little robot i made when i got bored.

(This is my first instructable please tell me if i did anything wrong)

Step 1: Materials

Picture of Materials

<1>Roll of electric tape
<3>Tiny piece of tape
<4>Small button cell battery(Any size will work i recomend small though)

Step 2: Motor

Picture of Motor

Fit the motor in and put the battery to where it is powering the motor.Then put the tape on to where the motor is running without you touching it.

Step 3: Spinning It

Picture of Spinning It

Grab it with two fingers on one side then one on the other.Then Spin it.It will take a couple tries to get it to keep going.

(Note:You dont have to spin it you can set it down and it will Move around)


About This Instructable



More by Tape56:Catnip Kat toysWater botTape Bot
Add instructable to: