With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
My tatted mask is made with cotton thread, swarovski crystals and a few small pieces of wire. You will need an intermediate to advanced knowledge of n...
Using your own eyes as a guide form an almond shape with the 17.5mm wire. Fold over at the corner and use the pliers to tighten down. You may cut off ...
Center: 8 picots(p) separated(sep) by 2 double stitches(ds), tie, cut and hide ends.Outside: ring(r) 8ds join to center picot(+) 8ds close(cl) revers...
Make 2First load 6 beads onto the thread for each medallion using a beading needle. Make the medallion in the same manner as the center medallion exce...
Starting at the top right of the center medallion:r 3ds join to top picot of clover 3ds join to wire 3ds 1p 3ds cl rw, chain(ch) 6ds 1p 3ds 1p 3ds 1p ...
First load 21 beads onto the thread, refer to photo for location to add them.Begin at the left side of mask: 3ds 1p 3ds join to first empty chain(see ...
First load 12 beads onto the thread for the bottom edge.Make a chain of 6 clovers the same as the ones on the medallions across each side of the botto...
You will need to make two rings to finish the nose portion. The rings are 4 picots sep by 3ds attach by side picots as shown.
Take the small piece of wire and weave into the back of the mask as shown. Fold over and attach to the eye wires. Make sure to stretch the lace a bit ...
This is perhaps the most time consuming step of the mask. Cut a long piece of thread and using the tatting needle, knot the thread over the wire repea...
Remove these ads by
Signing Up
Not NiceInappropriateSpam141,307 views
677 favorites
Posted:
Dec 6, 2008
License:
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »