Print PDF
Favorite
Email
Step 5Bear arms
The next step is to make the bear's arms which also function as the "on" switch. Cut out the bear arm pieces and attach the inner paw decoration similarly to the bear face. Hand sew one part of a metal snap fastener to the inside of one paw and the other to the outside of the other paw.
Sew the two sides of each paw together, reverse, and stuff each with cotton or polyester stuffing. Run the conductive threads corresponding to each arm through the arm and tie around the snap. Each snap should now connect to the sewn circuit by the conductive thread and the arms are hanging loosly from the bear body.
Sew the two sides of each paw together, reverse, and stuff each with cotton or polyester stuffing. Run the conductive threads corresponding to each arm through the arm and tie around the snap. Each snap should now connect to the sewn circuit by the conductive thread and the arms are hanging loosly from the bear body.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
4
Jan 1, 2008. 9:37 PM
flio191
says:
flio191
says:
dont put a comment inside of a bigger comment box, we cant select them! XD
Reply
 |
Add Comment
|
