Introduction: Temple: Adding Main Dome

Picture of Temple: Adding Main Dome

Instructions

  1. Press W to choose the Workplane Tool and select the bottom surface of the pointed dome.
  2. Press CTRL+C to copy the pointed dome to the clipboard.
  3. Continue to the next step.

Step 1: Align Workplane to Center Cylinder

Picture of Align Workplane to Center Cylinder

Instructions

  1. Press W to choose the Workplane Tool and select the top surface of the column.
  2. Press CTRL+V to paste a copy of the pointed dome on top of the column.

  3. If the dome is pointing down, rotate it so that it is pointing up.
  4. Continue to the next step.

Step 2: Scale the Dome

Picture of Scale the Dome

Instructions

  1. Scale the pointed dome to fit the large cylinder.
  2. Move as needed.
  3. Continue to the next step.

Step 3: Congratulations!

Congratulations!! You Finished!!

Comments

About This Instructable

85views

1favorite

License:

More by tinkercad-support:VEX IQ: Clawbot ScoopBalloon Powered CarExplore Buoyancy: Designing Sea Craft
Add instructable to: